Path A — Start a design
Start With an Idea. Leave With Production Electronics.
Bring a requirement, a reference product, a partial design or an early prototype. We take it through architecture, schematics, layout, BOM, firmware where scoped, prototype and U.S. production.
How a design starts
From Schematic to Board.
A design begins as electrical intent — sensing, power, interfaces, timing — captured in schematics, then resolved into a physical board that can be built repeatably.
What we design
Drone Electronics Only.
We do not design airframes, aerodynamics or full flight stacks. Electronics is the scope.
Flight Controllers
Custom electrical design · PCB · firmware · U.S. manufacturing
ESC & Motor Control
Custom current / voltage architecture · telemetry · U.S. PCBA
Power Electronics
Distribution · regulation · monitoring · high-current design
Radio & Data Links
Telemetry · communication boards · RF and data interfaces
GNSS & Sensors
GNSS · IMU · barometer · navigation electronics
Compute & Payload Interfaces
Carrier boards · payload controllers · camera and sensor interfaces
Design process
Requirement to Production.
- Idea
- Requirements
- Electrical Design
- Prototype
- Test
- Production
Requirements & architecture
Electrical requirements, interfaces, power budget, and the board-level architecture that satisfies them.
Schematics & layout
Schematic capture, PCB layout, DFM review, and fabrication-ready output.
Prototype & test
Board bring-up, functional test definition, iteration, then handoff to production.
Deliverables
You Keep Everything We Produce.
No black box. No unnecessary vendor lock-in.
Editable schematics
Native source, not a flattened PDF
PCB source files
Layout database you can keep editing
Gerbers
Fabrication-ready output
BOM
Full bill of materials with alternates where relevant
CPL / pick-and-place
Assembly data for any builder
Firmware source
Where firmware is in scope
Manufacturing documentation
Assembly and build notes
Test documentation
Functional test definition and results
Firmware scope
Firmware Is Project-Dependent.
- Board bring-up
- Embedded firmware
- Drivers
- Interfaces
- Hardware integration
A full autopilot stack or large software-system work is scoped separately.
Handoff
Prototype to Manufacturing, Without a Reset.
The design package that leaves engineering is the same package that enters production: Gerbers, BOM, CPL, assembly documentation and functional test definition. Nothing needs to be recreated to build the board at volume, by us or by anyone else.
Request a Design Quote.
Tell us what the board has to do. We will come back with scope, approach and cost.